# E2E Snapshot Rebase

Rebase E2E test snapshots based on failed tests from the PR comments.

## Instructions

1. Get the current PR number using `gh pr view --json number --jq '.number'`

2. Fetch PR comments and look for the Playwright test results comment. Parse out the failed test filenames from either:
   - The "Failed Tests" section (lines starting with `- \`filename.spec.ts`)
   - The "Update Snapshot Commands" section (contains `npm run e2e e2e-tests/filename.spec.ts`)

3. If no failed tests are found in the PR comments, inform the user and stop.

4. Run the pre-e2e setup:
   ```
   npm run pre:e2e
   ```

5. For each failed test file, run the e2e test with snapshot update:
   ```
   npm run e2e e2e-tests/<testFilename>.spec.ts -- --update-snapshots
   ```

6. After updating snapshots, re-run the same tests WITHOUT `--update-snapshots` to verify they pass consistently:
   ```
   npm run e2e e2e-tests/<testFilename>.spec.ts
   ```
   If any test fails on this verification run, inform the user that the snapshots may be flaky and stop.

7. Show the user which snapshots were updated using `git diff` on the snapshot files.

8. Review the snapshot changes to ensure they look reasonable and are consistent with the PR's purpose. Consider:
   - Do the changes align with what the PR is trying to accomplish?
   - Are there any unexpected or suspicious changes?

9. If the snapshots look reasonable, commit and push the changes:
   ```
   git add e2e-tests/snapshots/
   git commit -m "Update E2E snapshots"
   git push
   ```

10. Inform the user that the snapshots have been updated and pushed to the PR.
